500,000 BTU Rental Indirect Fired Heater

Model: IDF500L
This temporary indirect-fired heater is an ideal unit for a construction or manufacturing plant when heating is needed but moisture is to be avoided. At 500,000 BTU, this unit can help maintain temperature in many sizable spaces. Operating on LP or NG, the heater can easily be fixed to a fuel source and the heat can be ducted to any area of the job site or facility to provide clean, dry, warm air.  Two 12″ duct attachments can run heat to two different areas in your building.  Zero moisture and carbon monoxide will contaminate your heated space.  Can be placed indoors but requires a venting setup but can also side outside a building with ductwork attached, directing the warm, dry air where needed most.
  • Style: Indirect-Fired
  • Weight: 850 lbs.
  • Weight Range For Filtering: 501 – 1,000
  • Dimensions: 94″ x 32″ x 53″
  • Dedicated Power: YES
  • Safety: OSHA Compliant
  • Certified: CSA US CA / ANSI Z83.7
  • BTUs: 500000 BTUs
  • Extension Cord Max Length: 100′
  • ANSI Z83.7: Certified
  • Discharge Duct Length: 100′
  • Intake Duct Length: 50′
  • Discharge Duct Diameter: 12″ x 25′
  • Intake Duct Diameter: 20″ x 25′
  • Thermostat Setting: 55 degrees
  • Fuel Type: Natural Gas Or Liquid Propane
  • Pipe Fitting: 1″ Union Fitting
  • Regulator (Included): Maxitrol 325-7A-1212-0003
  • Natural Gas Min. Inlet Pressure: 14 w.c.
  • Propane Min. Inlet Pressure: 14 w.c.
  • Static Pressure: 2.5″
  • Fuel Consumption Therms: 5
  • Voltage: 120 Volt
  • Voltage Range For Filtering: 100 – 200
  • Phase: 1 PH
  • Amp Draw: 13.5 amps
  • Amp MCA: 20 amps
  • CFM: 3500 cfm

Protective goggles and gloves are recommended. Read and follow all safety information included in user manual prior to use.

Our rental process

Step 1: We work with you to calculate your industrial climate conditioning needs, properly size your project, and select equipment type and placement.

Step 2: We deliver and connect your equipment. We are available around the clock to provide maintenance, and repair services for your rental equipment.

Step 3: Upon request, we will perform safety and quality control checks, help monitor your project, and generate equipment reports.

Related equipment

Scroll to Top